ALPINE Mono subwoofer amplifier — 1,200 watts RMS x 1 at 2 ohms (MRVM1200)
Alpine makes it a little easier to get great bass in your vehicle. Their V-Power Series MRV-M1200 mono subwoofer amplifier can send up to 1,200 watts RMS to a sub, guaranteeing some truly powerful performance on your drive.
Earn 1394 VIP POINTS!
A low-pass filter puts you in command of the frequencies directed to your sub, while a bass boost lets you apply plenty of low-end punch. The amp includes preamp- and speaker-level inputs, so you can install it in almost any vehicle, even one with a factory radio. If you're using the speaker-level inputs, the amp senses an incoming signal and turns itself on, eliminating the need to run a turn-on wire run back to your vehicle's receiver or fusebox.
If you're a tweaker, you'll appreciate the end-piece terminal covers that can be snapped in and out without the need for any tools. And you can control the volume of your MRV-M1200 from the front seat with the included RUX-KNOB wired remote controller.
Thermal protection without annoying shut-downs
The MRV-M1200 uses a thermal management processor to roll back the output a bit when the amp threatens to overheat from playing at its limits too long. Instead of shutting down completely, it continues playing your music, until it cools enough to return to full power.
Features and Specs
|RMS Power Output (Watts x Channels)||600 x 1|
|Peak Power Output (Watts x Channels)||N/A|
|Power at 2 Ohms (Watts x Channels)||1200 x 1|
|Bridged Power (Watts x Channels)||N/A|
|Minimum Impedance Bridged||N/A|
|Minimum Impedance Unbridged||2|
|Best Frequency Response||7-400 Hz|
|THD at Rated RMS Power||1%|
|Signal to Noise Ratio||85 dB|
|Low-Pass Crossover Frequency||50-400 Hz|
|Low-Pass Slope (dB/octave)||24 dB/octave|
|High-Pass Crossover Frequency||N/A|
|High-Pass Slope (dB/octave)||N/A|
|Bass Boost||0-12 dB|
|Bass Boost Frequency||50 Hz|
|Speaker Level Inputs||Harness|
|Preamp Outputs||1 pair|
|Parts Warranty||1 Year|
|Labor Warranty||1 Year|