Shipping and delivery available
Select options at checkout
3-way system
The KXMA900.5 will also work well powering a 3-way system, with the Amp 1 channels running the tweeters, Amp 2 the woofers, and the Sub channel taking care of a subwoofer or two.
Made for marine use
This rugged amp features a conformal-coated circuit board for improved water and dust resistance, plus corrosion-resistant power connections, a gasket-sealed front cover, and stainless steel mounting hardware that won't rust all over your boat's gel coat or carpeting.
Connection perfection
Kicker employs their Fail-Safe Integration Technology (FIT2™) to reject noise and stop any interference generated by your boat's electronics, so you'll enjoy your music clean and pure. Speaker-level inputs make it possible to hook this amp up to almost any receiver or radio. Kicker also helps you set this amp's gain properly, by offering free test tones for downloading. You play a tone and turn the gain up until the gain knob glows red. Then, you turn it down until it just goes out, and the amp's gain is set perfectly. Kicker also includes a wired remote bass knob when you need to turn up the thump from the driver's seat.
Versatile controls behind the folding door
A gasket-sealed front door gives you quick and easy access to your amp's controls. You can tune for almost any kind of speaker, as the steeply-sloped high- and low-pass filters offer a wide range of adjustment. The filter section for the rear channels can be set up for bandpass operation — where both the high- and low-pass filters are engaged to allow only the frequencies between them to play — for optimizing the signal for midrange speakers in a 3-way system.
The subwoofer channel includes a bass boost for adding some kick to your music, along with a subsonic filter that eliminates the extra-low, inaudible frequencies that only waste your sub's energy.
Product highlights:
- 5-channel marine amplifier
- 75 watts RMS x 4 + 200 watts RMS x 1 at 4 ohms
- 125 watts RMS x 4 at 2 ohms + 400 watts RMS x 1 at 1 or 2 ohms
- 250 watts RMS x 2 bridged at 4 ohms + 400 watts RMS x 1 at 2 ohms
- subwoofer channel 1-ohm stable — 400 watts RMS (+/-10%) x 1 at 1 ohm)
- CEA-2006 compliant
- Class D amp technology
- gain knobs also function as clip lights
- Amp 1: variable high- or low-pass filter (10-500 Hz, 24 dB/octave), plus 10x switch
- Amp 2: variable high-pass (10-500 Hz, 24 dB/octave), low-pass (40-500 Hz, 24 dB/octave with 10x switch), or bandpass (engages both) filter
- Sub channel: variable low-pass filter (40-160 Hz, 24 dB/octave), subsonic filter (10-80 Hz, 24 dB/octave), and variable bass boost (0-6 dB at 40 Hz)
- wired remote bass knob control
Other Features:
- weather-resistant conformal-coated circuit boards
- front-mounted controls protected behind gasket-sealed fold-down door
- Fail-Safe Integration Technology eliminates noise from your vehicle's electrical system
- preamp and speaker-level inputs (speaker wire to RCA adapter required for speaker-level input)
- wiring and hardware not included with amplifier
- 4-gauge power and ground leads and a 100-amp fuse recommended
- for multiple amplifiers, an additional 100-amp in-line fuse between the distribution block and this amplifier is recommended
- dimensions: 12-3/4"W x 2-1/8"H x 8-5/16"D
- warranty: 2 years
Performance | ||
---|---|---|
RMS Power Output (Watts x Channels) | 75 x 4 | |
Frequency Response at Rated RMS Power | 20-20k Hz | |
THD at Rated RMS Power | 1% | |
Signal to Noise Ratio | 95 dB | |
Input Voltage | 14.4v | |
Peak Power Output (Watts x Channels) | N/A | |
Power at 2 Ohms (Watts x Channels) | 100 x 4 | |
Bridged Power (Watts x Channels) | 200 x 2 | |
Minimum Impedance Bridged | 4 | |
Minimum Impedance Unbridged | 2 | |
Features | ||
Amplifier Class | D | |
Low-Pass Crossover Frequency | 10-5000 Hz | |
Low-Pass Slope (dB/octave) | 24 dB/octave | |
High-Pass Crossover Frequency | 10-5000 Hz | |
High-Pass Slope (dB/octave) | 24 dB/octave | |
Bass Boost | 0-6 dB | |
Bass Boost Frequency | 40 Hz | |
Fan Cooled | No | |
Fuse Rating | 100 | |
Speaker Level Inputs | Yes | |
Preamp Outputs | No | |
Height (inches) | 2-3/16 | |
Width (inches) | 12-3/4 | |
Depth (inches) | 8-5/16 | |
Parts Warranty | 2 Years | |
Labor Warranty | 2 Years |
Payment & Security
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.